|
First, make sure that the voltage specifications and really take a good grounding line.
Second, make sure the motor steering and circulatory oil level high and low.
Third, regular maintenance and regular replacement cycle oil.
Fourth, when the mold is not installed, the machine, do not rise in pressure, in order to avoid damage caused by the machine.
Special attention to the matter as follows:
1, [temperature setting: according to the material requirements set with the test thermometer measured mold temperature set and make the appropriate correction.
2, [molding set: 0 to 0.3 seconds between the time the best value on the stop.
Stop time optimum value between 0 and 0.3 seconds.
3, [exhaust distance set: depending on the material needs of settings, the best value between 0.6 to 1.2 seconds.
4, [exhaust the number of settings: 1 to 5 times thinner product 1 or 2 times thicker (high).
5 Pressure Setting: thick (high) recommend the use of high / low pressure setting, the low pressure setting range of 30 ~ 50kg/cm ², high pressure is set depending on the nature of the product.
6, [the second exhaust Setting: a more than 10mm above the height of the molding material, the process of sulfur in the air difficult to discharge must use the second exhaust between 50 to 80 seconds according to the time of the sulfur decision to the secondary exhaust features the best use of time.
b setting of the second exhaust products, the conditions necessary for one to add a sulfur forming material and the molding material of higher order to set the secondary exhaust, if the secondary particles or color key of goods is not to set the secondary exhaust due to secondary particles or color key molding supplemented by auxiliary mold with the molding.
7, [the second feed settings: applied to thick (high) or the shape of the specific product needs set.
|
